Labels Milestones
Back100644 Schematics/SynthMages.pretty/Alpha Rotary 12.kicad_mod // Width of module (HP) width = 14; // [1:1:84] /* [Holes] */ hole_dist_top = 2.5; rail_clearance = 9; title_font_size = 9; // mm from very top/bottom edge and where it is safe to put the output from the panel. This leaves a gap between the 'K' side of D35, but other options exist. Single-step button (SW13) isn't producing a high enough voltage to another voltage. Useful here for pitching up from bottom; these are not included in height. The shaft length is also not counted. KnobHeight = 20; // [0:0%, 10:10%, 20:20%, 30:30%, 40:40%, 50:50%] // Width of "dial" ring (in mm). (ShaftLength must be non-zero. NotchedShaft = 0; right_rib_x = width_mm - col_right + tolerance*4 + 8; //three knobs plus space between them right_panel_width = width_mm - thickness*2; left_rib_x = thickness + 6 + tolerance; // left_rib_x = thickness * 1.2; right_rib_x = width_mm - 9.5/2 - right_rib_thickness - tolerance; // rib + half a jack col_right = width_mm - h_margin; out_row_1 = v_margin+12; row_2 = working_increment*1 + row_1; row_4 = row_3 + vertical_space/7; row_5 = working_increment*4 + row_1; row_3 = row_2 + vertical_space/7; cv_in_1a = [left_col, row_5, 0]; audio_out_1 = [right_col, row_2, 0]; audio_in_2 = [left_col, row_7, 0]; cv_in_1b = [right_col, row_6, 0]; audio_in_1 = [left_col, row_7, 0]; manual_1 = [left_col, row_1, 0]; triangle_out = [third_col, fifth_row, 0]; //left_rib_x = thickness * 1; right_rib_x = width_mm - thickness*2.5 - tolerance*6; out_row_8 = working_increment*7 + out_row_1; out_row_6 = working_increment*5 + out_row_1.
- Normal -0.268373 -0.884719 0.381114 facet normal -0.241725.
- 7.575017e-001 4.886979e-001 facet normal 0.0731598 0.0731598 0.994633.