Labels Milestones
Back(all go to same bus) - run/stop 2x Pushbutton switches, all 2pin: reset Pots, 3-pin: - Glide attenuator (B10k) (join two left pins from below - Glide, manual (A100k) (two left pins, from below - Glide, manual (A100k) (two left pins, from below Pots, 2-pin: - Glide, manual (A100k) (two left pins, from below Clock rate goes down when resistance goes up, opposite to expectation. Schematic fixes: Trim 5mm from vertical for both panels, to make fitting inside a case easier. Or 10mm if it can fit; losing the bodge area. Outs: Clock Out - 1K to U3-7 Glide section not working right, just pegging the output jacks bottom_row = v_margin + 12; row_1 = bottom_row + v_margin + 12; row_1 = bottom_row + v_margin + 12; top_row = height - v_margin - title_font_size*2; saw_out = [output_column, bottom_row, 0]; cv_in = [input_column, bottom_row, 0]; pwm_pot = [input_column + h_margin/2, bottom_row, 0]; cv_in = [input_column, bottom_row, 0]; pwm_duty = [width_mm - h_margin - working_width/8, row_3, 0]; cv_in_2b = [right_col, row_1, 0]; triangle_out = [third_col, fifth_row, 0]; //left_rib_x = thickness + 6 + tolerance; extra_depth = 75 + tolerance; // rib + half a jack col_right = width_mm - col_right + tolerance*4 + 8; //three knobs plus space between them right_panel_width = width_mm - thickness*2; slider_center = (width_mm - left_panel_width - right_panel_width)/2 + left_panel_width; slider_bottom = v_margin+8; module label(string, size=4, halign="center") { color([1,0,0]) linear_extrude(thickness+1) text(string, size, halign=halign, font=font); } From 0d3d72c49e606725216a5a9a4217e6c039d5a574 Mon Sep 17 00:00:00 2001 Subject: [PATCH] Add position for resistor between the pots unneeded for expected pot effect direction). 007cc05932 Go to file traces added but.
- Derivative portions. The MIT License (MIT) Copyright.
- 0.499991 0.866031 2.04283e-06 facet normal -1.691408e-02.
- -1.425907e-01 -2.870850e-03 9.897776e-01 facet normal -5.997151e-001.