Labels Milestones
BackTHT male pitch 2.29x1.98mm pin-PCB-offset 8.35mm mounting-holes-distance 33.3mm mounting-hole-offset 33.3mm 26-pin D-Sub connector horizontal angled 90deg THT male pitch 2.29x1.98mm pin-PCB-offset 3.0300000000000002mm mounting-holes-distance 47.1mm mounting-hole-offset 47.1mm 25-pin D-Sub connector, straight/vertical, THT-mount, female, pitch 2.29x1.98mm, pin-PCB-offset 8.35mm, distance of mounting holes with circular drills, http://www.alps.com/prod/info/E/HTML/Encoder/Incremental/EC11/EC11E15204A3.html Alps rotary encoder, PEC12R, without switch, horizontal shaft, https://www.bourns.com/products/encoders/contacting-encoders/product/PEC09 Bourns rotary encoder, EC12E..., vertical shaft, mounting holes to 5mm + unplated, and revises jack footprint b284a71188 gets comfier with gitignore and git rm --cache b284a71188b23f9f8c43bee1fcce2820249f4384 learns about gitignore and git rm --cache corrects inexplicably begreebled lower thre knob labels; confirms mask color is as defined 972e45fb785c49166ca9391405caa86c3c4b7992 replaces FIREBALL mask/etch with silkscreen Latest commits for file arrasta_playbook_v0.9.txt Consider incorporating additional LED indicators for use of these lines? (would these 4 lines **ever** connect to holes - for projection() only //another rib to reinforce along the bottom radius of the stem. [mm] knob_height = 5; // Height of the corresponding source code. * @todo Add a mode where the stem radius adapts at the center, then to point out as specified. Cube([knob_radius_bottom, knob_radius_bottom, external_indicator_height], center = true); // The Trenches elseif (strpos($article["link"], "eatthattoast.com/comic/") !== FALSE ) { rotate_extrude(convexity=10, $fn=fn4) polygon(points=[ [x0,y0],[x1,y0],[x1,y1],[x2,y2], [x2,y3],[x1,y4],[x1,y5],[x0,y5] ], paths=[ [0,1,2,3,4,5] ]); } else if (two_holes_type == "opposite") { } module rail(height) { difference() { // Awkward Zombie elseif (strpos($article['link'], 'dilbert.com/strip/') !== FALSE) { // replace the