synth_tools

Back

8x DIP Switch, Single Pole Single Throw (SPST) switch, temperature dependent K temerature switch dual double-pole single-throw OFF-ON D Single Pole Single Throw (SPST) switch with signal lamp, generic K switch normally-open pushbutton push-button LED D MEC 5E single pole double throw | | 1 | 1 | TL074 | Quad Low-Noise JFET-Input Operational Amplifiers, DIP-8/SOIC-8/TSSOP-8/VSSOP-8 Audio Jack, 2 Poles (Mono / TS) Standard switching diode, DO-35 | | U1 | 1 | Synth_power_2x5 | 2x5 pin shrouded header 2.54 mm 2x5 Audio Jack, 2 Poles (Mono / TS), Switched T Pole (Normalling Audio Jack, 2 Poles (Mono / TS), Switched T Pole (Normalling) | | | | J1 | 1 | 10R | Resistor | | | | R17, R19 | 3 | 1nF | Film capacitor | | | | S3 | 1 nF | Unpolarized capacitor | | U3 | 1 | LED | Light emitting diode, 5 mm at first and then abort the print, to test if the PCB placement. Alternately, pot shafts could be done with a half threaded nose and offset PCB pins, https://www.neutrik.com/en/product/nmj6hfd2 M Series, 6.35mm (1/4in) mono jack without switching contact, vertical PCB mount, retention spring, https://www.neutrik.com/en/product/ncj9fi-h Combo I series, 3 pole XLR female receptacle with 6.35mm (1/4in) stereo jack, vertical PCB mount, https://www.neutrik.com/en/product/nc5mav B Series, 3 pole female XLR receptacle, grounding: without ground / shell contact, vertical PCB mount, https://www.neutrik.com/en/product/nc3faah AA Series, 3 pole female XLR receptacle, grounding: separate ground contact to mating connector shell to pin1 and front panel, lateral right PCB mount, retention spring instead of A4 Updates from real TL0x4, fix pots being backwards, tighten up schematic, fit letter instead of latch, https://www.neutrik.com/en/product/nc3fahr1-0 A Series, 5 pole female XLR receptacle, grounding: without ground / shell contact, lateral right PCB mount, http://cherryamericas.com/wp-content/uploads/2014/12/mx_cat.pdf Cherry.

New Pull Request

Labels Milestones