1k | Resistor | | C2, C5, C6, C8, C9 Schottky Barrier Rectifier Diode, DO-41"/> Schottky Barrier Rectifier Diode, DO-41 D3, D4, D5, D8, D9, D10 | 8 "active_layer_preset": "All Copper Layers", re-re-remove the mysterious extra trace f33ea6a168 Add scad for v3.2 panel_tweaking Notes about component heights, swapping rotary and toggle switches Port in fixes from v1.1 007cc05932 Checkpoint after tweaking footprints some more, starting over at 14hp Added hard sync to schematic, laid out PCB with exploratory 8hp layout 2x Sockets, all three pins need wires: - glide in (sleeve and normal both GND - Gate out (could normal to TP10, optional 2x Toggle Switches, 3pin: 11 Toggle Switches, 2pin: - all step switches (all go to same bus) - run/stop 2x Pushbutton switches, all 2pin: - reset in - CV in implement a DC offset via non-inverting op-amp. - A CV in implement a DC offset via non-inverting op-amp. - A notable issue with this design is the license for the male part, as it is safe to put the output to allow printing without support when flipped over. * @todo Change the assembly order so that if ≥30 faces on.