Labels Milestones
BackVs 3 if the PCB is used. - LEDs go in long leg down (from the front Don't put R8 so close to R26 -- D36/R47 too close - Clock Rate - variable resist +6k between U2-8 and U2-9 Reset Sw - when pressed, short +12V and Reset In Pause CV In - U1-13 (can get at from top when assembled Stop Switch - 10 - center_adjust; center_col = width_mm/2; //mm third_col = 60.7-center_adjust; //mm cv_in = [h_margin, row_1, 0]; audio_out_2 = [right_col, row_5, 0]; audio_out_1 = [right_col, row_2, 0]; fm_lvl = [h_margin+working_width/8, row_3, 0]; cv_in_2b = [right_col, row_3, 0]; left_rib_x = thickness * 1.2; right_rib_x = width_mm - thickness*2; // draw a "vertical" wall to mount a circuit board to, dead center // pcb_holder(h=10, l=top_row-rail_clearance*2-15-thickness, th=1.15, wall_thickness=1); // lower h-rib reinforcer Latest commits for file Samba Reggae 2 Pages Rhythms Table of Contents Synth Wizards Modules Faceplate Style Notes Very much WIP; take these as suggestions until we get a bit revised README.md to rev 2 beta README.md | 29 aoKicad | 1 | SW_Push | Push button switch, push-to-open, generic, two pins