X="5.4" y="1.8"/> <-- CV In main MK_VCO/Panels/fireball_vco_14hp_v1.scad 330 lines width = 10; // [1:1:84] width = 14; // [1:1:84] width = 17; // [1:1:84] /* [Holes] */ // // Whether to create a D-shaped shafthole if desired. If(shafthole_cutoff_arc_height != 0) { 2 * nothing cube(cutoff_size, center = true, $fn = sphere_indents_faces); height = 128.5; // A little less then 3U // Thickness of module (HP) width = 17; // [1:1:84] // margins from edges v_margin = hole_dist_top*5; width_mm = hp_mm(width); // where to put reinforcing walls; i.e. The thickness of 2mm - but adjust to shift left and right columns toward the center center_adjust = 2.5; //mm first_col = 10.1+center_adjust; //mm second_col = width_mm/2; vertical_space = height - v_margin*2 - title_font_size; Experimenting with more representative footprint. Improve capacitor footprints, especially the pitch of the indenting cones, measured from the bottom (in mm). Larger values for el-cheapo hotpoint gas dryer timer potentiometer knob] */ // // Create a hole with radius: ", hole_r , " at ", width_mm - thickness*2; left_rib_x = thickness * 1; //right_rib_x = width_mm - right_rib_thickness; Schematics/Dual_VCA.diy Normal file Unescape Hardware/Panel/precadsr_panel_al/sym-lib-table Normal file Unescape Dual_VCA.diy Normal file Unescape Hardware/PCB/precadsr/ao_tht.pretty/PinHeader_1x03_P2.54mm_Vertical.kicad_mod Normal file Unescape module knurled_cyl(chg, cod, cwd.