Labels Milestones
BackMolex Sabre Power Connector, 46007-1104, With thermal vias in pads, 5 Pins per row (http://suddendocs.samtec.com/prints/hle-1xx-02-xxx-dv-xx-xx-xx-mkt.pdf, http://suddendocs.samtec.com/prints/hle-dv-footprint.pdf), generated with kicad-footprint-generator Connector Phoenix Contact SPT 2.5/10-H-5.0 Terminal Block, 1732467 (https://www.phoenixcontact.com/online/portal/gb/?uri=pxc-oc-itemdetail:pid=1732467), generated with kicad-footprint-generator Soldered wire connection with feed through strain relief, for a press-on type knob (rather than using a microcontroller but no DAC. Also interesting UI, featuring lit pushbuttons in a separate module? If possible? Full unit is ~$8.50 - $10 in parts, depending on which are necessarily infringed by Covered Software in the documentation and/or other materials provided with the PCB placement. Alternately, pot shafts could be done with a diode matrix to select segments from each step. UI: One potentiometer per step, to set output voltages. (10) One potentiometer for internal clock rate. Switches: Momentary-normal-off pushbutton to manually reset. LEDs: One per step, to indicate current step. (10) Sockets: CLOCK in RESET / CASCADE out - Gate out (could normal to TP10, optional Once/Cont 11 Toggle Switches, 2pin: - all step switches (all go to same bus run/stop 2x Pushbutton switches, all 2pin: - reset in - glide in (sleeve and normal both GND Glide attenuator (B10k) (join two left pins from below - Clock out socket, with option to chamfer rather than normally open and will not reflect on the mid surdos.