Labels Milestones
Back= CONN_1; IdModule = Socket_Arduino_Nano:Socket_Strip_Arduino_1x15; EndCmp BeginCmp TimeStamp = /551D9414; Reference = P6; ValeurCmp = CONN_1; IdModule = Socket_Arduino_Nano:1pin_Nano; EndCmp BeginCmp TimeStamp = /551D9496; Reference = P1; ValeurCmp = CONN_1; IdModule = Socket_Arduino_Nano:Socket_Strip_Arduino_1x15; EndCmp BeginCmp TimeStamp = /551D94EF; Reference = P1; ValeurCmp = Digital; IdModule = Socket_Arduino_Nano:1pin_Nano; EndCmp BeginCmp TimeStamp = /551D9496; Reference = P4; ValeurCmp = CONN_1; IdModule = Socket_Arduino_Nano:Socket_Strip_Arduino_1x15; EndCmp BeginCmp TimeStamp = /551D9432; Reference = P4; ValeurCmp = CONN_1; IdModule = Socket_Arduino_Nano:1pin_Nano; EndCmp Hardware/PCB/precadsr/precadsr.kicad_pcb Normal file View File Find and replace last few thin traces, fix teardrops and gnd fill Find and replace last few thin traces, fix teardrops and gnd fill Embiggen traces, add teardrops updated C5 footprint & tracing; schematic annotation Add 55k-ish resistor to coarse knob to fix - CV out - GATE out - GATE out // round shaft hole cylinder(r=shaft_radius,h=shaft_height, $fn=shaft_smoothness); if(shaft_is_flatted == true module set_screw_hole() { if(set_screw == true From cb3a50e19a42a9ab425057cfa1f9427c1c21d019 Mon Sep 17 00:00:00 2001 Subject: [PATCH] schematics tweaks README.md Normal file Unescape Hardware/PCB/precadsr/Kosmo_panel.pretty/Kosmo_Panel_Dual_Slotted_Mounting_Hole.kicad_mod Normal file View File Hardware/Panel/precadsr-panel/precadsr-panel.pretty/Bigger_Push_Switch_Hole.kicad_mod Normal file Unescape Schematics/SynthMages.pretty/Perfboard_3x12.kicad_mod Normal file Unescape and there could be used for hall sensors, drill 0.75mm (see NXP sot054_po.pdf TO-92 leads in-line, wide, drill 0.75mm (see NXP sot054_po.pdf TO-92 leads molded, narrow, drill 0.75mm (see.
New Pull Request