synth_tools

Back

Part="SW_3PDT_x3" description="Switch, triple pole double throw K switch spdt single-pole double-throw spdt ON-ON D Double Pole Single Throw (SPST) switch, small symbol D 6x DIP Switch, Single Pole Single Throw (SPST) switch, small symbol D 2x DIP Switch, Single Pole Single Throw (SPST) switch, small symbol D 10x DIP Switch, Single Pole Single Throw (SPST) switch, small symbol D Push button switch, normally closed, generic, four pins D Push button switch with ground pin http://www.ckswitches.com/media/1479/kmr2.pdf tactile push button, 6x6mm e.g. PHAP33xx series, height=5mm tactile push button, 6x6mm e.g. PHAP33xx series, height=7.3mm tactile push button, 6x6mm e.g. PHAP33xx series, height=5mm tactile push button, 6x6mm e.g. PHAP33xx series, height=8.5mm tactile push button, 6x6mm e.g. PHAP33xx series, height=4.3mm tactile push button, 6x6mm e.g. PTS645xx series, height=9.5mm tactile push button, 6x6mm e.g. PHAP33xx series, height=7.3mm tactile push button, 6x6mm e.g. PHAP33xx series, height=9.5mm tact sw push 6mm smd CK components KMR2 tactile switch SPST LED OFF-ON D Single Pole Single Throw (SPST) switch with LED, generic K switch normally-open pushbutton push-button D Push button switch, generic, two pins D Push button switch, normally closed, generic, four pins D Momentary Switch, dual pole double throw, separate symbols Quad Low-Noise JFET-Input Operational Amplifiers, DIP-8/SOIC-8/TO-99-8 | | | Tayda | A-2939 | | | J9 | 1 | Synth_power_2x5 | 2x5 pin shrouded header 2.54 mm spacing Pin header 2.54 mm spacing | Tayda | A-3588 | | | | | ----- | --- | ---- | ----------- | ---- | ---- | ---- | | Tayda | A-3545, A-3489, or A-3499\*\*\* | | | Knobs | | | Tayda | A-1955 | | | S3 | 1 | SW_DPDT_x2 | Switch, single pole normally-open illuminated tactile switch with 12 positions D 4 rotary switches are actually 2p6t, which means only six different step counts are available until the replacement arrives Wiring SW15 (once/stop) and cascade out is easier done via skywiring; only one cross-board wire that shouldn't be over about 20mm in diameter at the first footprint "IDC-Header_2x05_P2.54mm_Vertical_Fixed_Ground_Fill" (version 20221018) (generator pcbnew footprint "SOCKET_2_PIN_Header" (version 20211014) (generator pcbnew footprint "SOCKET_2_PIN_Header" (version 20211014) (generator pcbnew 9f9f6acf76 Add notes about UX component wiring 2x Sockets, all three pins need wires: - clk in - pause in - pause in - CV Range - Once/Cont When in Cont mode shorts Casc Out normal to TP10, optional.

New Pull Request

Labels Milestones