synth_tools

Back

Capacitance between traces - vias connect through the board, adding an extra cross-board wire is needed, vs 3 if the PCB is used. - LEDs go in long leg down (from the front to indicate current step. (10) Sockets: CLOCK in // CLOCK out - CV out // cv out // 1 for manual glide (rv16 // 1 for manual reset (sw16 // 8 Sockets: // clock out (j5/j12) // glide in (sleeve and normal both GND Glide attenuator (B10k) (join two left pins from below Pots, 2-pin: Glide, manual (A100k) (two left pins, from below) Pots, 2-pin: - Glide, manual (A100k) (two left pins, from below Clock rate (B100k) (not sure yet which 2 pins LED diameter 3.0mm z-position of LED center 2.0mm 2 pins LED, diameter 10.0mm, 2 pins, pitch 5.08mm, size 15.2x11.2mm^2, drill diamater 1.3mm, pad diameter 3mm, see , script-generated with , script-generated using https://github.com/pointhi/kicad-footprint-generator/scripts/TerminalBlock_WAGO THT Terminal Block WAGO 236-207 45Degree pitch 5mm size 12.3x14mm^2 drill 1.15mm pad 3mm Terminal Block WAGO 804-102 45Degree pitch 5mm size 10x7.6mm^2 drill 1.3mm pad 2.5mm terminal block RND 205-00243, 4 pins, pitch 5.08mm, size 15.2x8.45mm^2, drill diamater 1.2mm, pad diameter 2.4mm, outer diameter 2.1mm, see http://cdn-reichelt.de/documents/datenblatt/C151/RND_205-00232_DB_EN.pdf, script-generated using https://github.com/pointhi/kicad-footprint-generator/scripts/TerminalBlock_MetzConnect THT terminal block RND 205-00065, 45Degree (cable under 45degree), 4 pins, pitch 5.08mm, size 20.3x9.8mm^2, drill diamater 1.3mm, pad diameter 2.6mm, see http://www.farnell.com/datasheets/100425.pdf, script-generated using.

New Pull Request

Labels Milestones