Labels Milestones
Back1, "opacity": { More tweaks after pro review "design_settings": { "defaults": { PCB initial layout, no traces One SPST switch to disable reset (run once). - Momentary-normal-off pushbutton to manually reset. LEDs: One per step, to set clock rate (if onboard clock is used) (rv11 // once/continuous (sw15 // 2 NO Moment switches: // 1 for manual reset (sw16 // 8 Sockets: // clock out (j5/j12 // glide atten (rv15 // glide in (sleeve and normal both GND Glide attenuator (B10k) (join two left pins from below Clock rate (B100k) (not sure yet which 2 pins diameter 3.0mm 2 pins IR-ED, diameter 3.0mm, hole diameter 1.0mm THT pad as test point, pitch 7.62mm, hole diameter 0.7mm, wire diameter 0.5mm test point SMD pad as test point, pitch 5.08mm, size 45.7x9.8mm^2, drill diamater 1.3mm, pad diameter.
- 8.9 mm (350 mils), SMDSocket.
- Http://rohmfs.rohm.com/en/products/databook/datasheet/ic/motor/dc/bd621x-e.pdf SC-59, hand-soldering varaint, https://lib.chipdip.ru/images/import_diod/original/SOT-23_SC-59.jpg SOT, 3 Pin.
- Https://www.te.com/usa-en/product-440055-2.datasheet.pdf connector header hdr horizontal right-angle.