Labels Milestones
BackJack combo i Combo I series, 3 pole male XLR receptacle, grounding: ground contact to mating connector shell and front panel, steel retention lug, lateral right PCB mount, https://www.neutrik.com/en/product/nc3fah2 A Series, 3 pole female receptacle, grounding: without ground / shell contact, vertical PCB mount, asymmetric push, https://www.neutrik.com/en/product/nc3faav1-da AA Series, 3 pole male XLR receptacle, switching contacts, grounding: separate ground contact to mating connector shell and front panel, vertical PCB mount, https://www.neutrik.com/en/product/nc3mbv-sw B Series, 3 pole female XLR receptacle, grounding: separate ground contact to mating connector shell and front panel, lateral left PCB mount, retention spring, https://www.neutrik.com/en/product/ncj9fi-v Combo I series, 3 pole XLR female receptacle with 6.35mm (1/4in) stereo jack, metal nose, gold plated contacts, fully threaded nose, https://www.neutrik.com/en/product/nrj4hh Slim Jacks, 6.35mm (1/4in) stereo jack, switched, fully threaded nose, https://www.neutrik.com/en/product/nrj4hf Slim Jacks, 6.35mm (1/4in) switching stereo jack, vertical PCB mount, retention spring instead of latch, https://www.neutrik.com/en/product/nc3fahr-0 A Series, 3 pole female XLR receptacle, switching contacts, grounding: separate ground contact to mating connector shell and front panel, vertical PCB mount, https://www.neutrik.com/en/product/nc3mav B Series, 3 pole female XLR receptacle, switching contacts, grounding: separate ground contact to mating connector shell and front panel. Possibly do as an addendum to the jack body made the height about right. It's easier to adjust parameters for. 1.0 2012-03-?? Initial release at https://www.thingiverse.com/thing:20513 . * @todo Add a front-panel PCB "net_color_mode": 1, "opacity": { More tweaks after pro review More tweaks after pro review PSU/Synth Mages Power Word Stun Panel.kicad_prl Normal file Unescape Panels/10_step_seq_40hp_v1.scad Normal file Unescape \+12V, -12V and ground needed, probably up to it. For example, if you don't want a shaft, set this to zero. ShaftLength = 0; right_rib_x = width_mm - thickness*2; slider_center = (width_mm - left_panel_width - right_panel_width)/2 + left_panel_width; slider_bottom = v_margin+12; Experimenting with more panel layout ideas left_rib_x = hole_dist_side + thickness; right_rib_x = width_mm - thickness*2.2.
New Pull Request