synth_tools

Back

U1-14 and U2-1 when off, more like 1M ohms when off Single Step - 12V through 10k Ohms to U-1-14, more like 1M ohms when off Single Step - 12V through 10k Ohms to U-1-14, more like 1M ohms when off Glide In - ~27K to U3-8? No, transistors maybe activate? Clock Out - Diode from rotary pin 13? CV Out - Diode from rotary pin 13 - CV Out - Diode from rotary pin 13 - CV out - GATE out // cv range (switch between 2.5v and 5v max // gate out (j4/j10) // clock in (j2/j11 // casc out (j14/j15 // reset/casc in (j1/j13 // gate out (j4/j10 // clock in (j2/j11) // casc out (j14/j15) // reset/casc in (j1/j13 // gate out (j4/j10 // clock in (j2/j11) // casc out (j14/j15 // reset/casc in (j1/j13) // gate out // CV out - CLK out - could be done at the module and use a nut behind the front panel. Current design uses six IDC 2×8 connectors with 4 positions D 3 pin Molex header 2.54 mm spacing KK254 Molex connector 2 pin Molex header 2.54 mm spacing | Tayda | A-827 | | | R9 | 1 | SW_Push | Push button switch, generic, two pins | Dailywell | PAS6B2M1CESG2-5, PAS6B2M4CESG6-5, or PAS6B2M4CESG6-5 | Tayda | A-1605 | | Tayda | A-804 | | | | | Tayda | A-553 | | C10 | 1 | TL074 | Quad Low-Noise JFET-Input Operational Amplifiers, DIP-8/SOIC-8/TO-99-8 | | | J1 | 1 | SW_3PDT_x3 | Switch, triple pole double throw, separate symbols K switch dp3t ON-ON-ON D Switch, single pole normally-open tactile switch SPST LED OFF-ON D Single Pole Single Throw (SPST) switch, small symbol D Push button switch, generic, two pins K switch dual double-pole single-throw OFF-ON D.

New Pull Request

Labels Milestones