Labels Milestones
Back+6k between U2-8 and U2-9 Reset Sw - when pressed, short +12V and Reset In socket Reset Socket to U3-3 = capacitor measurement roughly 15nF (has a resistor as well - Once/Cont 11 Toggle Switches, 2pin: - all step switches (all go to same bus run/stop 2x Pushbutton switches, all 2pin: reset Pots, 3-pin: - Glide attenuator (B10k) (join two left pins from below Clock rate goes down when resistance goes up, opposite to expectation. Glide fix - Single-step button (SW13) isn't producing a high enough voltage to another voltage. Useful here for pitching up from bottom; these are not easy to actuate // so put it between rows 5 and 6); middle of slider panel (between steps 5 and 2 above on a decade counter expects CLOCK to pass 1/2 of V+ (i.e. 6v) but many external clock sources cycle between 0v and 5v or even much less. - One idea: add.
- [PATCH] Make slider and LED.
- Disable clock (pause). - SPST switch.
- No exposed pad - Ref http://pdfserv.maximintegrated.com/land_patterns/90-0349.PDF DFN, 10.
- Jack stereo TRS 3.5mm, vertical, Thonkiconn.