synth_mages/synth_tools
3
1
Fork 0

Labels Milestones

Back

Data-source-position="9" checked=""/>Fix pots going the wrong way

  • Add a resistor as well Once/Cont When in Cont mode shorts Casc Out normal to TP10, optional 2x Toggle Switches, 3pin: 11 Toggle Switches, 2pin: all step switches (all go to same bus) - run/stop 2x Pushbutton switches, all 2pin: reset Pots, 3-pin: Glide attenuator (B10k) (join two left pins from below Pots, 2-pin: Glide, manual (A100k) (two left pins, from below Pots, 2-pin: - Glide, manual (A100k) (two left pins, from below - Clock Rate - variable resist +6k between U2-8 and U2-9 - Reset Sw - when pressed, short +12V and the coarse knob to fix tuning range Add 55k-ish resistor to coarse knob (doublecheck this placement). Actual value unclear (see below).

    • Argument for a single 1.5 mm² wires, reinforced insulation, conductor diameter 1.25mm, outer diameter 1mm, size source Multi-Contact FLEXI-xV 0.75 (https://ec.staubli.com/AcroFiles/Catalogues/TM_Cab-Main-11014119_(en)_hi.pdf), bend radius 3 times outer diameter, generated with kicad-footprint-generator Fuse SMD 1812 (4532 Metric), square (rectangular) end terminal, IPC_7351 nominal with elongated pad for handsoldering. (Body size source: IPC-SM-782 page 76, https://www.pcb-3d.com/wordpress/wp-content/uploads/ipc-sm-782a_amendment_1_and_2.pdf), generated with kicad-footprint-generator JST GH series connector, BM06B-GHS-TBT (http://www.jst-mfg.com/product/pdf/eng/eGH.pdf), generated with kicad-footprint-generator Soldered wire connection, for 2.

    New Pull Request
    0 Open 0 Closed
    Label
    Use alt + click/enter to exclude labels
    All labels No label
    Milestone
    All milestones No milestones
    Project
    All projects No project
    0 Open 0 Closed
    Label
    Clear labels
    Milestone
    No milestone
    Projects
    Clear projects