Labels Milestones
BackOut is easier done via skywiring; only one tl074 and support components, so tiny PCB should be possible, too * Manual trigger * See manual step (sw13 // 1 rotary switch, 5+ positions - 10 ohms between U1-14 and U2-1 when off, more like 1M when off Single Step - 12V through 10k Ohms to U-1-14, more like 1M when off Glide In - diode to U2-3 Clock In - U1-13 (can get at from top when assembled Stop Switch - 10 - center_adjust; center_col = width_mm/2; //mm third_col = 60.7-center_adjust; //mm cv_in = [input_column, row_2, 0]; fm_lvl = [second_col, fourth_row, 0]; triangle_out = [width_mm-h_margin-working_width/4, row_1, 0]; saw_out = [output_column, bottom_row, 0]; c_tune = [width_mm/2 + h_margin, top_row, 0]; left_rib_x = thickness * 1; right_rib_x = width_mm - thickness*2; left_rib_x = thickness + 6 + tolerance; rotate_vector_cos = 0.94; // 'x' of 20 degree rotation rotate_vector_sin = 0.34; // 'y' of rotation left_edge = -rotate_vector_sin * rail_depth; right_edge = height - v_margin; working_increment = working_height / 6; // generally-useful spacing amount for vertical columns of stuff left_panel_width = 12*3 + tolerance*2; // rib + half a jack col_right = width_mm - col_right - thickness; left_panel_spacing = left_panel_width / 3 + tolerance*8; echo("Left panel:", left_panel_width, " with spacing ", left_panel_spacing); right_panel_width = width_mm - hole_dist_side - thickness; left_panel_spacing = left_panel_width / 3 + tolerance*8; echo("Left panel:", left_panel_width, " with spacing ", left_panel_spacing); right_panel_width = width_mm - hole_dist_side - thickness; // How much horizontal space needed for left-hand and right-hand sub-panels left_panel_width = 12.5*3 + tolerance*4 + 8; //three knobs plus space between two resistors Properly assign potentiometer pads and trace routing to de-bodge the pots. D5bfb6e27b.
- 2x49 1.27mm double row Through hole angled pin.
- MKDS-1,5-14 pitch 5mm size 40x8.1mm^2 drill 1.1mm pad.