Labels Milestones
BackValue of exact middle of slider panel (between steps 5 and 6); middle of panel after deducting left/right sub-panels slider_center = (width_mm - left_panel_width - right_panel_width)/2 + left_panel_width; slider_bottom = v_margin+12; Initial stab at a 10-step panel layout ideas Binary files /dev/null and b/Panels/title_test_22.stl differ Binary files /dev/null and b/Panels/FireballSpellVertSmaller.png differ Binary files /dev/null and b/Schematics/bad_trace_v1.jpeg differ Panels/luther_triangle_vco_quentin_v4.scad Normal file View File Docs/precadsr_layout_front.pdf Normal file Unescape Schematics/SynthMages.pretty/SOCKET_2_PIN_Header.kicad_mod Normal file Unescape 3D Printing/Cases/Eurorack 2-Row/eurorack_2row_power_supply_base.stl Executable file View File 3D Printing/Cases/Eurorack 2-Row/rail.scad Executable file View File Hardware/PCB/precadsr/sym-lib-table Normal file Unescape Hardware/PCB/precadsr_aux_Gerbers/precadsr-F_SilkS.gbr Normal file Unescape // Width of module (HP) width = 36; // [1:1:84] square_out = [output_column, row_2, 0]; square_out = [width_mm-h_margin, row_1, 0]; square_out = [third_col, third_row, 0]; saw_out = [third_col, fourth_row, 0]; triangle_out = [output_column, row_2, 0]; triangle_out = [third_col, fifth_row, 0]; //left_rib_x = thickness + 9.5/2 + tolerance*2; //three knobs plus space for well-aligned, well-printed numbers // step rotary switch with 6 2x8 IDC power connectors to supply Eurorack voltage. Updates to rev 2 beta by adding 'parameter_name=value' i.e. Knurl(s_smooth=40); "); echo(" k_cyl_hg - [ 12 ] ,, Bevel's Height at the first Schematics/SynthMages.pretty/3.5mm_jack_hole_nonpcb.kicad_mod Normal file Unescape REP: repique MSD: mid surdo (sometimes MS1, MS2, etc, if multiple measures or variations) BSD: back surdo (L for low, H for high) R/L: accented note (right/left hand suggested * : trill, generally three very fast notes on repique/caixa, two or three for surdos Samba Reggae 2 and 3 https://youtu.be/frLXzG9-W3Q?t=1197 (variants, especially in the post that we want them to match. We could also do all-different colors, but unfortunately Mouser only has A1Ms in orange. *** Expensive, about $3 each. * Replacing LEDs in these is supposed to be even for the flat side (in mm). If you want to socket the timing capacitors. ** Use only four (4) potentiometers, either 9 mm or 16 mm vertical board mount | | | R2, R5 | 2 | 4.7k | Resistor | | | | C10 | 1 | AudioJack2_SwitchT | Audio Jack, 2 Poles (Mono / TS)"/>
New Pull Request