3
1
Back

Sub-panels right_panel_width = width_mm - thickness*2; slider_center = (width_mm - left_panel_width - right_panel_width)/2 + left_panel_width; slider_bottom = v_margin+12; // draw a "vertical" wall to mount the circuit board to, dead center // pcb_holder(h=10, l=top_row-rail_clearance*2-15-thickness, th=1.15, wall_thickness=1); // lower h-rib reinforcer cylinder(r=hole_r, h=thickness*2); echo("Putting a hole with radius: ", hole_r , " at ", width_mm - thickness*2; slider_center = (width_mm - left_panel_width - right_panel_width)/2 + left_panel_width; slider_bottom = v_margin+12; row_2 = row_1 + v_margin + 12; row_1 .

New Pull Request