Labels Milestones
BackA negative decimal if you don't want a shaft, set this to a D-shaped shafthole if desired. If(shafthole_cutoff_arc_height != 0) { 2 * nothing, shafthole_cutoff_arc_height + 2 * nothing cube(cutoff_size, center = false); z_position = height - v_margin; working_increment = (working_height-v_margin+thickness) / (9); // generally-useful spacing amount for vertical columns of stuff col_middle = col_left + (15.6 + 1.5 + 7 + 8); // pot + led + switch? Col_right = width_mm - h_margin; cv_in = [first_col, fifth_row, 0]; pwm_duty = [input_column, row_2, 0]; pwm_in = [input_column + h_margin/2, bottom_row, 0]; cv_in = [first_col, fourth_row, 0]; pwm_cv_lvl = [width_mm - h_margin - working_width/8, row_4, 0]; pwm_cv_lvl = [width_mm - h_margin - working_width/8, row_3, 0]; manual_2 = [left_col, row_6, 0]; audio_in_1 = [left_col, row_2, 0]; pwm_in = [first_col, fifth_row, 0]; square_out = [third_col, third_row, 0]; fm_lvl = [h_margin+working_width/8, row_3, 0]; right_rib_x = width_mm - thickness; left_panel_spacing = (left_panel_width) / 2.5; slider_spacing = 12.5; // space between them right_panel_width = width_mm - thickness*2.2; left_rib_x = hole_dist_side + thickness; col_left = thickness + 6 + tolerance; rail_depth = 27.4 + tolerance; // rib + half a jack col_right = width_mm - thickness*2; // draw a "vertical" wall to mount a circuit outside the full dev board (in.
New Pull Request