synth_tools

Back

Need wires: - clk in - CV out /* [Default values] */ // Four hole threshold (HP cv_in = [input_column, row_2, 0]; pwm_in = [first_col, first_row, 0]; //Second row interface placement f_tune = [second_col, first_row, 0]; c_tune = [second_col, third_row, 0]; fm_lvl = [second_col, fourth_row, 0]; triangle_out = [output_column, bottom_row, 0]; pwm_duty = [input_column, bottom_row, 0]; pwm_pot = [input_column - h_margin/2, row_1, 0]; fm_in = [input_column + h_margin/2, bottom_row, 0]; pwm_pot = [input_column - h_margin/2, bottom_row, 0]; pwm_pot = [input_column - h_margin/2, bottom_row, 0]; pwm_duty = [input_column, bottom_row, 0]; cv_in = [input_column, bottom_row, 0]; pwm_pot = [input_column - h_margin/2, bottom_row, 0]; pwm_duty = [second_col, second_row, 0]; //Third row interface placement f_tune = [width_mm/2 + h_margin, top_row, 0]; f_tune = [second_col, fifth_row, 0]; square_out = [width_mm-h_margin, row_1, 0]; pwm_in = [first_col, third_row, 0]; fm_in = [first_col, third_row, 0]; //Fourth row interface placement sync_in = [first_col, third_row, 0]; fm_lvl = [h_margin+working_width/8, row_3, 0]; pwm_duty = [input_column, row_2, 0]; pwm_in = [first_col, fifth_row, 0]; square_out = [width_mm-h_margin, row_1, 0]; pwm_in = [first_col, fifth_row, 0]; //right_rib_x = width_mm - thickness*2; // draw a "vertical" wall to mount the 3PDT so these issues don't arise. Then again, that would make for 7 wires to run, so maybe not. It works this way. "pcb_color": "rgba(0, 0, 0, 0.000)", "track_width": 0.25, "via_diameter": 0.8, "via_drill": 0.4, More tweaks after pro review More tweaks after pro review "spice_external_command": "spice \"%I\"", More tweaks after pro review More tweaks after pro review More tweaks after pro review "multiple_net_names": "warning", "net_not_bus_member": "warning", "no_connect_connected": "warning", "no_connect_dangling": "warning", "pin_not_connected": "error", "pin_not_driven": "error", "pin_to_pin": "warning", "power_pin_not_driven": "error", "similar_labels": "warning", More tweaks after pro review "spice_external_command": "spice \"%I\"", Inkscape export via OpenSCAD DXF.

New Pull Request

Labels Milestones