Labels Milestones
BackHttps://www.thingiverse.com/thing:20513 . Open Tasks // ====================================================================== knob(); // Entry point of the shaft on the bottom of the board, connecting a trace on one side //calculated x value of exact middle of slider panel (between steps 5 and 6); middle of panel after deducting left/right sub-panels slider_center = (width_mm - left_panel_width - right_panel_width)/2 + left_panel_width; panel(width); // Top left: clock in, speed pot_p160(); // Left side: meta-step controls // step rotary switch? Special: this needs measuring, and leaving space for everything, lining things up more c5efc87d8e Make slider and LED footprints match current OpenSCAD model Make slider and LED footprints match current OpenSCAD model .gitignore | 1 | 4.7 uF | Unpolarized capacitor | | | 14 pin DIP socket | | | J2 | 1 | Synth_power_2x5 | 2x5 pin shrouded header 2.54 mm spacing | Tayda | A-553 | | | S3 | 1 | AudioJack2_SwitchT | Audio Jack, 2 Poles (Mono / TS)"/>
New Pull Request