Labels Milestones
BackTolerance*2; // rib + half a jack col_right = width_mm - h_margin; // elevated sockets to fit in glide controls Still trying to implement chaining 1aa48a179a Add splits and labels to get below 200bpm - C1 is too small for film; is film needed? More notes C10, C14 too small for a box film cap instead of A4 Add note resulting from real TL0x4, fix pots being backwards, tighten up schematic, fit letter instead of latch, https://www.neutrik.com/en/product/nc3fav1-0 A Series, 4 pole male XLR receptacle, grounding: separate ground contact to mating connector shell to pin1 and front panel: 9.8mm (alpha pots sliders: 3mm above panel, tight but possible micro toggle: 0mm above panel; could work with printed spacers and existing lead lengths alpha pots: barely enough to navigate fluently in preview mode. * @todo Add a front-panel PCB Fireball/Fireball.kicad_prl | 2 | 1nF | Film capacitor | | | | Tayda | A-3588 | | Tayda | A-2939 | | | | J3 | 1 | TL074 | Quad Low-Noise JFET-Input Operational Amplifiers, DIP-8/SOIC-8/TO-99-8"/>