Labels Milestones
BackFrom 54fe4830602c83b6eac304b75796acbd9fc37ea8 Mon Sep 17 00:00:00 2001 Subject: [PATCH] More work finding space for everything, lining things up more More work finding space for everything, lining things up more More work finding space for everything, lining things up more c5efc87d8e Make slider and LED footprints match current OpenSCAD model Checkpoint after tweaking footprints some more, starting over at 14hp cd18ed43dc Added hard sync input. - But could also do all-different colors, but unfortunately Mouser only has A1Ms in orange. * Expensive, about $3 each. Replacing LEDs in these is supposed to be +1mm between legs -- Don't put R8 so close to R26 -- D36/R47 too close - Clock Rate - variable resist +6k between U2-8 and U2-9 Reset Sw - when pressed, short +12V and Reset In socket Reset Socket to U3-3 = capacitor measurement roughly 15nF (has a resistor footprint between +12V and Reset In socket Reset Socket to U3-3 = capacitor measurement roughly 15nF (has a resistor as well Once/Cont When in Cont mode shorts Casc Out normal to TP10, optional) - Casc out 2x Toggle Switches, 2pin: - step - reset Pots, 3-pin: - Glide attenuator (B10k) (join two left pins from below) - Clock rate (B100k) (not sure yet which 2 pins LED, diameter 3.0mm z-position of LED center 1.0mm 2 pins LED_Rectangular, Rectangular, Rectangular size 5.0x2.0mm^2 z-position of LED center 1.0mm, 2 pins, diameter 3.0mm SMD pad as test point.
- VCT, 28 Pin (https://www.semtech.com/uploads/documents/sx1272.pdf#page=125), generated with kicad-footprint-generator Soldered.
- Polyswitch Littelfuse, resettable fuse, PTC, polyswitch LVR100.
- If (bottom_element=="switch") { } .
- 8de432ba4663cc4e208cff778a114b9ae41e7906 Mon Sep 17 00:00:00 2001.
- Used 10.25mm, but this.