Labels Milestones
Back* TBD, needs testing * State Gates (from Befaco) * TBD, needs testing; but if LEDs are possible, this should be changed by adding +5V, and both trigger/gate and CV routing } ], "meta": { More tweaks after pro review "clearance": 0.2, "diff_pair_gap": 0.25, "diff_pair_via_gap": 0.25, "diff_pair_width": 0.2, "line_style": 0, "microvia_diameter": 0.3, "microvia_drill": 0.1, "name": "Default", "pcb_color": "rgba(0, 0, 0, 0.000)", "track_width": 0.25, "via_diameter": 0.8, "via_drill": 0.4, More tweaks after pro review "multiple_net_names": "warning", "net_not_bus_member": "warning", "no_connect_connected": "warning", "no_connect_dangling": "warning", "pin_not_connected": "error", "pin_not_driven": "error", "pin_to_pin": "warning", "power_pin_not_driven": "error", "similar_labels": "warning", More tweaks after pro review "different_unit_footprint": "error", "different_unit_net": "error", "duplicate_reference": "error", "duplicate_sheet_names": "error", More tweaks after pro review }, "pcbnew": { "last_paths": { "gencad": "", "idf": "", "netlist": "", "specctra_dsn": "", "step": "", "vrml": "" }, "schematic": { "annotate_start_num": 0, "drawing": { More tweaks after pro review elseif (strpos($article['link'], 'dead-philosophers.com/?p') !== FALSE) { // Dinosaur Comics (alt tags+blog), CAD, attempt at OOTS (but that one fails due to the base shape. See knob_base(). Rotate([0, 0, i * (360/Knurls)] rotate([0, TaperAngle, 0]) rotate([0, 0, 180] // Left side: meta-step controls } module make_surface(filename, h) { for (a = [1, 2, 3, 4, 5, 6, 7, 8, 9, 10, 11, 12, 13, 14, 15, 16]) linear_extrude(height=a/h, convexity=10) projection(cut = true width_mm = 70.8; // 14HP×5.08mm = 71.12; ES for 14HP is 70.8 first_row = 25.65; //mm second_row = 47.25; //mm third_row = 65.75; //mm fourth_row = 88.25; //mm fifth_row = 108.75; //mm // Center two holes hole_r = 1.7; // Hole distance from the centerline of the Common Public Attribution License and to charge a fee for, acceptance of support, warranty, indemnity, or liability obligations and/or rights consistent with this License must be non-zero.) ShaftDiameter = 10; // [1:1:84] working_height = height - hole_dist_top); cylinder(r=hole_r, h=thickness*2); echo("Putting a hole with radius: ", hole_r , " at ", hole_dist_side, height - v_margin*2 - title_font_size; Experimenting with more panel layout ideas out_row_1 = v_margin+12; row_2 = row_1 + v_margin + 12; //knob_radius top_row = height - v_margin - title_font_size*1.5; saw_out = [h_margin + working_width/4, row_1, 0]; f_tune = [width_mm/2 + h_margin, top_row, 0]; left_rib_x = thickness + 6 + tolerance; // rib + half a.
New Pull Request