3
1
Back

= [h_margin + working_width/4, row_1, 0]; fm_pot = [input_column + h_margin/2, row_1, 0]; square_out = [width_mm-h_margin, row_1, 0]; audio_out_2 = [right_col, row_6, 0]; audio_in_1 = [left_col, row_2, 0]; cv_2b_atten = [right_col, row_1, 0]; pwm_in = [input_column - h_margin/2, bottom_row, 0]; c_tune = [width_mm/2 + h_margin, top_row, 0]; left_rib_x = thickness * 2; right_rib_x = width_mm - hole_dist_side - thickness; // draw panel, subtract holes // v_wall(h=4, l=height-rail_clearance*2-thickness); // top right [left_edge + height * rotate_vector_cos; [left_edge, rotate_vector_cos * rail_depth], // top horizontal rib h_wall(h=4, l=right_rib_x); // one more to mount the circuit board to, dead center // one more vertical to mount a circuit board sideways on module x1_7seg_14_22mm_display() { cube([12.25, 19.25, thickness]); } // Make sure.

New Pull Request