Labels Milestones
BackFour more switches/buttons, move LED drivers onto PCB 496e3e3344 Correcting changed filename in .prl gets jiggy with PCB cutout, light-direction downwards, see http://www.kodenshi.co.jp/products/pdf/sensor/photointerrupter_ref/SG-105.pdf Laser Diode, TO-38-ICut, 3pin Laser Diode, TO18-like (D=5.6mm), 3pin Laser Diode, TO5-like (D=9mm), 3pin Laser Diode, TO18-like (D=5.6mm), 3pin Laser Diode, TO-56, 3pin lightpipe triple tower right angle http://www.alps.com/prod/info/E/HTML/Tact/SnapIn/SKHH/SKHHLUA010.html tactile switch SPST right angle, PTS645VL31-2 LFS C&K Button tactile switch with 12 positions D 4 rotary switches are actually 2p6t, which means only six different step counts are available until the replacement arrives - Wiring SW15 (once/stop) and cascade out is easier done via skywiring; only one cross-board wire that shouldn't be so hard. - In general, try to avoid putting any UX connections on the larger board underneath the smaller board, for convenience Casc Out normal to Reset In socket - Reset Socket to U3-3 = capacitor measurement roughly 15nF (has a resistor as well - Once/Cont 11 Toggle Switches, 3pin: - CV Range - Once/Cont 11 Toggle Switches, 2pin: - reset in - CV Range - Once/Cont When in Cont mode shorts Casc Out normal to Reset In socket Reset Socket to U3-3 = capacitor measurement roughly 15nF (has a resistor as well Once/Cont When in Cont mode shorts Casc Out normal to TP10, optional) - Casc Out - 1K to U3-7 Glide section not working right, just pegging the output jacks working_height = height - v_margin - title_font_size*1.5; top_row = height - v_margin - title_font; saw_out = [third_col, fifth_row, 0]; pwm_duty = [second_col, fifth_row, 0]; //left_rib_x = thickness + 6 + tolerance; rotate_vector_cos = 0.94; // 'x' of 20 degree rotation rotate_vector_sin = 0.34; // 'y' of rotation left_edge = -rotate_vector_sin * rail_depth; right_edge = height - v_margin; working_increment = (working_height-v_margin+thickness) / (9); // generally-useful spacing amount for vertical columns of stuff col_left = h_margin; bottom_row = v_margin + 12; row_2 = row_1 + v_margin + 12; //knob_radius top_row = height - v_margin*2 - title_font_size; working_increment = working_height / 7; // rows up from bottom; these are for steps only row_1 = v_margin+12; row_2 = row_1 + v_margin .
- 3.463406e-04 facet normal 4.937034e-001 -8.439927e-001.
- 35.6x10.6mm^2, drill diamater 1.3mm.
- 12, module knurled_cyl(chg, cod, cwd, csh.
- Normal 0.491815 -0.403619 0.771499 vertex -7.11876 -4.7566.
- -7.38567 1.36686 6.0001 facet normal 0.0961519.