Labels Milestones
BackSymbol, four pins D Push button switch | | | D1, D2 | 2 Smaller cap (476nF?) for C1 - Ceramic 104s for C10, C14, might be fine, might introduce intermittents - Don't put R8 so close to R26 - D36/R47 too close - Clock In Normal - 1k to U2-8 (AND NOT short to U2-10 Clock Rate - variable resist +6k between U2-8 and U2-9 - Reset Socket to U3-3 = capacitor measurement roughly 15nF (has a resistor as well - Once/Cont When in Cont mode shorts Casc Out normal to TP10, optional 2x Toggle Switches, 2pin: - reset Pots, 3-pin: - Glide attenuator (B10k) (join two left pins from below - Clock In - U1-13 (can get at from top when assembled - Stop Switch - 10 - center_adjust; center_col = width_mm/2; //mm third_col = 60.7-center_adjust; //mm cv_in = [first_col, fourth_row, 0]; triangle_out = [third_col, fifth_row, 0]; square_out = [width_mm-h_margin, row_1, 0]; saw_out = [third_col, fourth_row, 0]; //Fifth row interface placement f_tune = [width_mm/2 + h_margin, top_row, 0]; left_rib_x = 0; // [0:No, 1:Yes] // 0 if indicator faces notch, 180 if it faces away and so on. Use