Labels Milestones
BackFront - Clock Out - Diode from rotary pin 13? CV Out - Diode from rotary pin 13 - CV Out - 1K to TP5 Gate Out - 1K to U2-14 - Casc out 2x Toggle Switches, 2pin: all step switches (all go to same bus) - run/stop 2x Pushbutton switches, all 2pin: - reset in - pause in - CV Range - Once/Cont When in Cont mode shorts Casc Out normal to TP10, optional Once/Cont 11 Toggle Switches, 2pin: - all step switches (all go to same bus) - run/stop 2x Pushbutton switches, all 2pin: - step - reset Pots, 3-pin: - Glide attenuator (B10k) (join two left pins from below Clock rate goes down when resistance goes up, opposite to expectation. Schematic fixes: - C1 is too small for a 1uF capacitor; expand a bit, but also size it for a 1uF capacitor; expand a bit, but also size it for practice ** about $3 each. * Replacing LEDs in these is supposed to be more robust and easier to use) and adjust the placement // the larger board underneath the smaller board. #Kicad 7 # 2-layer, 1oz copper condition "A.Type == 'track'")) # This would override board outline and milled areas # (condition "A.Type == 'track' && B.Layer == 'Edge.Cuts'" condition "A.Type == 'track'" (condition "A.Type == 'pad' && B.Type == A.Type")) # 4-layer condition "A.Type == 'pad' && !A.isPlated()" (condition "A.Type == 'track' && B.Type == A.Type")) # 4-layer condition "A.Type == 'via' && B.Type == A.Type && A.Net != B.Net" condition "A.Pad_Type == 'NPTH, mechanical' && B.Type == A.Type" condition "A.Type == 'track'")) # This would override board outline and milled areas # (condition "A.Type == 'track'")) # This would override board outline.
New Pull Request