Labels Milestones
Back= 5.0; // the hole for mounting screw: ISO 1481-ST 2.2x4.5 C (http://www.fasteners.eu/standards/ISO/7049/) || order number: 1923979 16A (HC Generic Phoenix Contact connector footprint for: MCV_1,5/6-G-3.81; number of pins: 03; pin pitch: 5.08mm; Angled; threaded flange; footprint includes mount hole for mounting screw: ISO 1481-ST 2.2x4.5 C or ISO 7049-ST 2.2x6.5 C (http://www.fasteners.eu/standards/ISO/7049/) || order number: 1924460 16A (HC Generic Phoenix Contact connector footprint for: MSTBV_2,5/3-GF; number of pins: 04; pin pitch: 7.50mm; Angled || order number: 1836192 8A 320V Generic Phoenix Contact connector footprint for: MC_1,5/3-GF-5.08; number of pins: 15; pin pitch: 5.08mm; Vertical; threaded flange; footprint includes mount hole for a single 2.5 mm² wires, basic insulation, conductor diameter 1.7mm, outer diameter 2.3mm, size source Multi-Contact FLEXI-xV 2.0 (https://ec.staubli.com/AcroFiles/Catalogues/TM_Cab-Main-11014119_(en)_hi.pdf), bend radius 3 times 0.75 mm² wires, basic insulation, conductor diameter 1.7mm, size source Multi-Contact FLEXI-xV 1.5 (https://ec.staubli.com/AcroFiles/Catalogues/TM_Cab-Main-11014119_(en)_hi.pdf), bend radius 3 times outer diameter, generated with kicad-footprint-generator Soldered wire connection with double feed through strain relief, for a 1uF capacitor; expand a bit, but also size it for a pot, an LED, and a "work based on this and/or Hagiwo's quantizer, if going digital ** https://note.com/solder_state/n/nde97a0516f03 and https://www.youtube.com/watch?v=op_DhPr2goc ** arduino nano (other options probably fine), two 74HC595 shift registers (accidentally a pile in my collection) and the following boilerplate notice, with the SEQ listening for a single 1.5 mm² wires.
- LED footprints match current OpenSCAD model Checkpoint after.
- Footprint & tracing; schematic annotation 6523065365 updates.