Labels Milestones
BackFrom 750478ab8360c0ef45b55687504a3e4846b752b4 Mon Sep 17 00:00:00 2001 Subject: [PATCH] Added input resistor for sync; placed everything on PCB Added hard sync to schematic, laid out PCB with on-board components PCB initial layout, no traces Using the Precision ADSR with retriggering and looping modifications This is a D shaped shaft. Enter the same order). One looked about the same, see datasheet: https://www.mouser.com/datasheet/2/54/PTL-777483.pdf (page 4) if we want them to match. We could also do all-different colors, but unfortunately Mouser only has A1Ms in orange. Replacing LEDs in sliders, lit for each stage? * TBD, needs testing * State Gates (from Befaco) * TBD, needs testing; but if LEDs are possible, this should be possible, too * Manual trigger * See manual step (sw13 // 1 for 5v / 2.5v output mode // 10 steps (sw1-sw10 // 1 rotary switch, 5+ positions - 10 ohms between U1-14 and U2-1 when off, more like 1M when off - Single Step - 12V through 10k.
- NF, Bold';font-variant-ligatures:normal;font-variant-caps:normal;font-variant-numeric:normal;font-feature-settings:normal;text-align:center;writing-mode:lr-tb;text-anchor:middle;stroke-width:0.0104167">LOOPING d="M 2.4803098,6.8897683.
- (end 6.09 -2.01 (end -1.01 2.73 (end 0.8.