synth_tools

Back

1.5*1; MarkingWidth = 1.5*1; DistanceBetweenKnurls = 3*1; TimerKnobConst = 1.8*1; PI=3.14159265*1; KnobMajorRadius = KnobDiameter/2; KnobMinorRadius = KnobDiameter/2 * (1 - TaperPercentage/100); KnobRadius = KnobMinorRadius + (KnobMajorRadius-KnobMinorRadius)/2; KnobCircumference = PI*KnobDiameter; Knurls = round(KnobCircumference/DistanceBetweenKnurls); Divot=CapType; TaperAngle=asin(KnobHeight / (sqrt(pow(KnobHeight, 2) + pow(KnobMajorRadius-KnobMinorRadius,2)))) - 90; DivotRadius = KnobMinorRadius*.4; // Primary knob cylinder for (i=[0 : Knurls-1] rotate([0, 0, 180] // Left side: meta-step controls // step (manual) -- this is the license here: http://creativecommons.org/licenses/by-nc-sa/3.0/ version history --------------- 1.1 2012-04-12 fixed the arrow indicator code to this height controls label depth label_inset_height = thickness-1; // Width of module (HP width = 24; // [1:1:84] //Second row interface placement fm_in = [input_column + h_margin/2, row_1, 0]; fm_in = [first_col, fourth_row, 0]; //Fifth row interface placement square_out = [third_col, fourth_row, 0]; triangle_out = [output_column, bottom_row, 0]; c_tune = [second_col, fourth_row, 0]; triangle_out = [output_column, row_1, 0]; triangle_out = [width_mm-h_margin-working_width/4, row_1, 0]; fm_pot = [input_column - h_margin/2, row_1, 0]; triangle_out = [width_mm-h_margin-working_width/4, row_1, 0]; pwm_in = [width_mm - h_margin - working_width/8, row_3, 0]; pwm_duty = [second_col, fourth_row, 0]; pwm_cv_lvl = [second_col, fourth_row, 0]; pwm_cv_lvl = [second_col, first_row, 0]; c_tune = [second_col, fourth_row, 0]; pwm_in = [input_column + h_margin/2, bottom_row, 0]; fm_in = [input_column + h_margin/2, bottom_row, 0]; c_tune = [second_col, first_row, 0]; c_tune = [width_mm/2, top_row, 0]; left_rib_x = hole_dist_side + thickness; col_left = thickness * 1; right_rib_x = width_mm - thickness*2.2; left_rib_x = thickness + 6.

New Pull Request

Labels Milestones