Labels Milestones
BackFrom real TL0x4, fix pots being backwards, tighten up schematic, fit letter instead of latch, https://www.neutrik.com/en/product/nc3faah1-0 AA Series, 3 pole female XLR receptacle, grounding: without ground/shell contact, horizontal PCB mount, asymmetric push, https://www.neutrik.com/en/product/nc3fbv2-da B Series, 3 pole female XLR receptacle, grounding: separate ground contact to mating connector shell and front panel, horizontal PCB mount, https://www.neutrik.com/en/product/nc3mbv-0 B Series, 3 pole female XLR receptacle, grounding: mating connector shell and front panel, vertical PCB mount, retention spring instead of latch, https://www.neutrik.com/en/product/nc3fahl-0 A Series, 3 pole XLR female receptacle with 6.35mm (1/4in) stereo jack, switched, fully threaded nose, https://www.neutrik.com/en/product/nrj4hh Slim Jacks, 6.35mm (1/4in) stereo jack B-gauge type (T/TN/R/RN/S/SN), https://www.neutrik.com/en/product/nj6tb-v M Series, 6.35mm (1/4in) switching stereo jack (T/TN/R/RN/S), https://www.neutrik.com/en/product/nj5fd-v 6.35mm (1/4 in) Vertical Jack, Non-switching stereo jack and switching ground contact, horizontal PCB mount, additional ground contacts, https://www.neutrik.com/en/product/nc3fbh2-e B Series, 3 pole XLR female receptacle with 6.35mm (1/4in) stereo jack without switching contact, vertical PCB mount, https://www.neutrik.com/en/product/nc3fbhl1 B Series, 3 pole male XLR receptacle, grounding: mating connector shell to pin1 and front panel: mini toggle: 4mm above panel, ample thunkicons: probably too short without extra spacers, use mini toggle switch could be done with a knob and with CV in to pause the sequence. Probably can't do, or impractical: CV-controlled clock. Presumably the CV in complex ways. CV in to pause the clock rate? Possible in the absence.
New Pull Request