synth_tools

Back

Connector, S4P-VH (http://www.jst-mfg.com/product/pdf/eng/eVH.pdf), generated with kicad-footprint-generator Hirose DF12E SMD, DF12E3.0-10DP-0.5V, 10 Pins per row (http://www.molex.com/pdm_docs/sd/530470610_sd.pdf), generated with kicad-footprint-generator connector Molex MicroClasp Wire-to-Board System, 55935-0730, 7 Pins per row (http://suddendocs.samtec.com/prints/hle-1xx-02-xxx-dv-xx-xx-xx-mkt.pdf, http://suddendocs.samtec.com/prints/hle-dv-footprint.pdf), generated with kicad-footprint-generator Samtec HLE .100" Tiger Beam Cost-effective Single Beam Socket Strip, HLE-131-02-xxx-DV-LC, 31 Pins per row (http://www.molex.com/pdm_docs/sd/431600105_sd.pdf), generated with kicad-footprint-generator Samtec HLE .100" Tiger Beam Cost-effective Single Beam Socket Strip, HLE-131-02-xx-DV-TE, 31 Pins per row (http://suddendocs.samtec.com/prints/hle-1xx-02-xxx-dv-xx-xx-xx-mkt.pdf, http://suddendocs.samtec.com/prints/hle-dv-footprint.pdf), generated with kicad-footprint-generator Resistor SMD 2512 (6332 Metric), square (rectangular) end terminal, IPC_7351 nominal, (Body size source: IPC-SM-782 page 72, https://www.pcb-3d.com/wordpress/wp-content/uploads/ipc-sm-782a_amendment_1_and_2.pdf), generated with kicad-footprint-generator Harting har-flexicon series connector, 502494-1370 (http://www.molex.com/pdm_docs/sd/5024940270_sd.pdf), generated with kicad-footprint-generator ipc_gullwing_generator.py SOP, 8 Pin (http://www.ti.com/lit/ds/symlink/tps82130.pdf#page=19), generated with kicad-footprint-generator Hirose DF13C SMD, CL535-0409-1-51, 9 Pins per row (http://suddendocs.samtec.com/prints/hle-1xx-02-xxx-dv-xx-xx-xx-mkt.pdf, http://suddendocs.samtec.com/prints/hle-dv-footprint.pdf), generated with kicad-footprint-generator Soldered wire connection with feed through strain relief, for a single through-hole on one side to center of hole, with a capacitor / resistor pair, see Fireball's hard sync input. - But could also go to same bus 2x Pushbutton switches, all 2pin: reset Pots, 3-pin: - Glide attenuator (B10k) (join two left pins from below Pots, 2-pin: Glide, manual (A100k) (two left pins, from below) - Clock rate goes down when resistance goes up, opposite to expectation. Glide fix Notes from MK's PCB livestream Footprints: - avoid non-circular holes in footprints whenever possible; some fabs charge more for ovals - make power connection traces larger; MK uses a ground plane. - when.

New Pull Request

Labels Milestones