Labels Milestones
BackRate. One SPDT switch to adjust CV output range, switch between 5v and 2.5v max (or whatever is configured). - Momentary-normal-off pushbutton to manually reset. LEDs: One per step, to set output voltages. (10) One potentiometer per step, to indicate direction? Pointer1 = 0; // [0:No, 1:Yes] TaperAngle=asin(KnobHeight / (sqrt(pow(KnobHeight, 2) pow(KnobMajorRadius-KnobMinorRadius,2)))) - 90; hole_right = hole_left + 78.5; 0d370a24cd Add VCA shaek layout Add schematic, start on PCB with on-board components Added hard sync to schematic, laid out PCB with exploratory 8hp layout 2x Sockets, all three pins need wires: glide in (sleeve and normal both GND) 6x Sockets, 2pin: - all step switches (all go to same bus) - run/stop 2x.
- 0.915281 0.396623 0.0703598 vertex -3.09288 7.88052 17.8205.
- 5.756167e-001 7.010823e+000 2.496000e+001 vertex 1.380968e+000 -5.529187e+000.
- 9.281117e+01 3.455000e+01 vertex -9.289963e+01 9.327794e+01 3.455000e+01 vertex -9.738418e+01.
- Size 60x10.3mm^2 drill 1.3mm pad 2.6mm Terminal Block.