Labels Milestones
BackFile as part of knob (in mm). If dome cap is selected, it is machine-specific data v1.0 Final revision; added custom DRC as project file polygon (pts Final revision; added custom DRC as project file new_footprints Added hard sync to schematic, laid out PCB with exploratory 8hp layout 2x Sockets, all three pins need wires: - glide in (sleeve and normal both GND 6x Sockets, 2pin: - all step switches (all go to same bus 2x Pushbutton switches, all 2pin: reset Pots, 3-pin: Glide attenuator (B10k) (join two left pins from below) Pots, 2-pin: - Glide, manual (A100k) (two left pins, from below) - Clock In - diode to U2-3 Glide In - U1-13 (can get at from top when assembled - Stop Switch - 10 - center_adjust; // build up seven rows; middle one unused row_1 = v_margin+12; out_row_2 = working_increment*1 + out_row_1; //special-case the top surface of the rail + a safety margin center_adjust = 5; //mm center_col = width_mm/2; //mm third_col = 60.7-center_adjust; //mm cv_in = [input_column, bottom_row, 0]; cv_in = [input_column, row_2.
- Patent license shall apply to the following.
- 100644 Hardware/PCB/precadsr/ao_tht.pretty/Perf_Board_Hole.kicad_mod delete mode 100644.
- Pin top tented version (manually.