Labels Milestones
BackBut are not easy to actuate // so put it between rows 5 and 6); middle of slider panel (between steps 5 and 6); middle of panel after deducting left/right sub-panels slider_center = (width_mm - left_panel_width - right_panel_width)/2 + left_panel_width; slider_bottom = v_margin+8; Panels/10_step_seq_38hp_v1.scad Normal file View File Schematics/Baby8_Part4_Cascading.pdf Normal file View File Hardware/PCB/precadsr_Gerbers/precadsr-B_Mask.gbr Normal file Unescape Hardware/PCB/precadsr_aux_Gerbers/precadsr-PTH.drl Normal file Unescape Hardware/Panel/precadsr-panel/precadsr-panel.kicad_pro Normal file Unescape 2x Sockets, all three pins need wires: - clk in - glide in (sleeve and normal both GND Glide attenuator (B10k) (join two left pins from below Pots, 2-pin: Glide, manual (A100k) (two left pins, from below Clock rate goes down when resistance goes up, opposite to expectation. Schematic fixes: Trim 5mm from vertical for both panels.
- Middle and bottom boards. Latest commits.
- THN 10 to 30W, Single or dual Output.
- Pin pitch=19.00mm, , diameter=21mm, Vishay.