Labels Milestones
Back5mm from vertical for both panels, to make fitting inside a case easier. Or 10mm if it faces away and so on. // body - hole // begin arrow top cutout cylinder(r=8, h=10, $fn=3, center=true); for (z = [0 : sphere_indents_count]) { z_position = sphere_indents_radius + (enable_stem ? Stem_height : 0) + knob_height - cone_indents_cutdepth; for (z = [0:cylinder_number_of_indentations] cylinder(r1=radius_of_cylinder_indentations_bottom, r2=radius_of_cylinder_indentations_top, h=height_of_cylinder_indentations, center=true, $fn=cylinder_quality_of_indentations); Latest commits for file VCO_MANUAL_v2.pdf 2015-02-23 19:36:11 -0800 08c0726655 2015-02-23 04:32:30 -0800 01f0c6a8ec 2015-02-23 04:26:05 -0800 5663c8bc86 2015-02-23 04:25:44 -08:00 * Okay, instead of latch, https://www.neutrik.com/en/product/nc3fah2-0 A Series, 3 pole female XLR receptacle, grounding: separate ground contact to mating connector shell and front panel, steel retention lug, horizontal PCB mount, https://www.neutrik.com/en/product/nc3fav2 A Series, 5 pole female XLR receptacle, grounding: separate ground contact to mating connector shell and front panel, lateral left PCB mount, https://www.neutrik.com/en/product/nc3fbv1 B Series, 5 pole female XLR receptacle, grounding: separate ground contact to mating connector shell to pin1 and front panel, horizontal PCB mount, retention spring instead of latch, https://www.neutrik.com/en/product/nc3fav2-0 A Series, 3 pole male XLR receptacle, grounding: separate ground contact to.
New Pull Request