3
1
Back

H_margin/2, row_1, 0]; square_out = [third_col, fifth_row, 0]; //right_rib_x = width_mm - 10 - center_adjust; center_col = width_mm/2; //mm third_col = 60.7-center_adjust; //mm cv_in = [input_column, row_2, 0]; triangle_out = [third_col, fifth_row, 0]; pwm_duty = [second_col, second_row, 0]; //Third row interface placement square_out = [output_column, row_2, 0]; triangle_out = [third_col, fourth_row, 0]; //Fifth row interface placement pwm_in = [input_column + h_margin/2, bottom_row, 0]; pwm_pot = [input_column - h_margin/2, bottom_row, 0]; pwm_duty = [input_column, bottom_row, 0]; c_tune = [width_mm/2 - h_margin, top_row, 0]; left_rib_x = thickness * 1.2; right_rib_x = width_mm - col_right; // column from edge plus hole radius //calculated x value of exact middle of panel after deducting left/right sub-panels slider_center = (width_mm - left_panel_width - right_panel_width)/2 + left_panel_width; panel(width); // waves out wall(h=4, w=width_mm-hole_dist_top-4); // one more vertical.

New Pull Request