Labels Milestones
BackEffect because it is not cut by the indenting cones. // Number of faces around the top (mm) hole_dist_top = 2.5; // margins from edges h_margin = hole_dist_side + thickness; v_margin = hole_dist_top*2 + thickness; right_rib_x = width_mm - 9.5/2 - right_rib_thickness - tolerance; // rib + half a jack col_right = width_mm - thickness; // How much horizontal space needed for left-hand and right-hand sub-panels left_panel_width = 12*3 + tolerance*2; // rib + half a jack col_right = width_mm - thickness*2; // draw panel, subtract holes // label the whole thing? // surface("FIREBALL VCO.png", center=true, invert=false); More experimentation with panel alignment before printing Add notes about UX component wiring 2x Sockets, all three pins need wires: - glide in (sleeve and normal both GND 6x Sockets, 2pin: - reset in - glide in (sleeve and normal both GND 6x Sockets, 2pin: - all step switches (all go to same bus run/stop 2x Pushbutton switches, all 2pin: - all step switches (all go to same bus) - run/stop 2x Pushbutton switches, all 2pin: - Glide attenuator (B10k) (join two left pins from below - Clock rate goes down when resistance goes up, opposite to expectation. Glide fix - CV Range - Once/Cont 11 Toggle Switches, 3pin: 11 Toggle.
- Stencil (https://www.infineon.com/dgdl/ir4301.pdf?fileId=5546d462533600a4015355d5fc691819, https://www.infineon.com/dgdl/Infineon-AN1170-AN-v05_00-EN.pdf?fileId=5546d462533600a40153559ac3e51134 PQFN 44 leads, 7x7mm.
- 0]; square_out = [third_col, third_row, 0]; fm_lvl .
- | A-805 | | | C1.