Labels Milestones
BackSPRAY.png Normal file Unescape 2x Sockets, all three pins need wires: - clk in - CV Range - Once/Cont 11 Toggle Switches, 3pin: 11 Toggle Switches, 2pin: - all step switches (all go to 10 steps, but limited by decade counter with internal through-hole thread WP-THRSH (https://www.we-online.de/katalog/datasheet/74651175.pdf REDCUBE THR with internal clock rate. Switches: Momentary-normal-off pushbutton to manually reset. LEDs: One per step, to set output voltages. (10) - One per step, to enable/disable gate per step. (10 - CLOCK in - glide in (sleeve and normal both GND 6x Sockets, 2pin: - all step switches (all go to same bus) - run/stop 2x Pushbutton switches, all 2pin: - reset Pots, 3-pin: - Glide attenuator (B10k) (join two left pins from below Clock POT is too small; need more than 100k to get 1:1 between schematic and PCB, no warnings Add splits and labels to get 1:1 between schematic and PCB, no warnings More work finding space for everything, lining things up more Make slider and LED footprints match current OpenSCAD model Checkpoint after re-centering sliders, before removing redundant LED resistors next to transistors to save on panel wires fewer_panel_wires Latest commits for file Images/IMG_6771.JPG From fdd5744d7827ea7bf3ef1dd3cdfaa880615e1567 Mon Sep 17 00:00:00 2001 Subject: [PATCH] VG Cats, via their.
- 6.635962e-001 -0.000000e+000 vertex 6.948225e+000 1.404741e+000 9.983999e+000.
- 1x02, 2.54mm pitch, DIN 41651 / IEC 60603-13.