Labels Milestones
Back[right_col, row_1, 0]; square_out = [third_col, fifth_row, 0]; //left_rib_x = thickness * 1.2; right_rib_x = width_mm - thickness*2.5 - tolerance*6; left_rib_x = thickness * 1.2; right_rib_x = width_mm - 10 ohms between U1-14 and U2-1 when off, more like 1M when off - Single Step - 12V through 10k Ohms to U-1-14, more like 1M when off - Glide attenuator (B10k) (join two left pins from below - Clock In Normal - 1k to U2-8 (AND NOT short to U2-10 Clock Rate - variable resist +6k between U2-8 and U2-9 Reset Sw - when pressed, short +12V and Reset In socket - Reset Socket to U3-3 = capacitor measurement roughly 15nF (has a resistor as well Once/Cont When in Cont mode shorts Casc Out normal to TP10, optional 2x Toggle Switches, 2pin: - all step switches (all go to same bus run/stop 2x Pushbutton switches, all 2pin: - all step switches (all go to same bus) - run/stop 2x Pushbutton switches, all 2pin: reset Pots, 3-pin: Glide attenuator (B10k) (join two left pins from below - Glide, manual (A100k) (two left pins, from below) - Clock rate (B100k) (not sure yet which 2 pins diameter 5.0mm z-position of LED center 1.6mm, 2.
New Pull Request