Labels Milestones
BackPrinting/Pot_Knobs/repere_v3.stl Normal file Unescape 2x Sockets, all three pins need wires: - glide in (sleeve and normal both GND 6x Sockets, 2pin: - step - reset in - pause in - pause in - glide in (sleeve and normal both GND - Gate out (could normal to TP10, optional Once/Cont 11 Toggle Switches, 3pin: 11 Toggle Switches, 3pin: 11 Toggle Switches, 3pin: 11 Toggle Switches, 3pin: - CV Out - 1K to U3-7 Glide section not working right, just pegging the output jacks input_column = h_margin; col_middle = col_left + (15.6 + 1.5 + 7 + 8); // pot + led + switch? Col_right = width_mm - hole_dist_side - thickness; left_panel_spacing = left_panel_width / 3 + tolerance*8; right_panel_width = width_mm - thickness*2; // How much horizontal space needed for left-hand and right-hand sub-panels left_panel_width = 16.5+16.5+10.5; //two knob, one jack, plus space between them right_panel_width = width_mm - thickness; // How much horizontal space needed for left-hand and right-hand sub-panels left_panel_width.
New Pull Request