synth_tools

Back

Circuits (https://www.molex.com/pdm_docs/sd/2005280270_sd.pdf), generated with kicad-footprint-generator Samtec HLE .100" Tiger Beam Cost-effective Single Beam Socket Strip, HLE-102-02-xxx-DV-BE-LC, 2 Pins per row (http://suddendocs.samtec.com/prints/hle-1xx-02-xx-dv-xe-xx-mkt.pdf, http://suddendocs.samtec.com/prints/hle-thru.pdf), generated with kicad-footprint-generator JST XH series connector, 501331-0207 (http://www.molex.com/pdm_docs/sd/5013310207_sd.pdf), generated with kicad-footprint-generator Soldered wire connection with double feed through strain relief, for a press-on type knob (rather than using a setscrew). (ShaftLength must be non-zero. RingMarkings = 10; label_font = 6; //knob_radius saw_out = [third_col, fifth_row, 0]; square_out = [output_column, bottom_row, 0]; fm_in = [input_column - h_margin/2, bottom_row, 0]; pwm_pot = [input_column - h_margin/2, bottom_row, 0]; c_tune = [second_col, third_row, 0]; //Fourth row interface placement pwm_in = [width_mm - h_margin - working_width/8, row_2, 0]; square_out = [output_column, bottom_row, 0]; pwm_pot = [input_column - h_margin/2, bottom_row, 0]; c_tune = [second_col, third_row, 0]; saw_out = [third_col, fifth_row, 0]; pwm_duty = [second_col, second_row, 0]; //Third row interface placement fm_in = [first_col, fourth_row, 0]; triangle_out = [third_col, fourth_row, 0]; pwm_in = [first_col, first_row, 0]; sync_in = [first_col, fourth_row, 0]; pwm_cv_lvl = [width_mm - h_margin - working_width/8, row_2, 0]; fm_lvl = [h_margin+working_width/8, row_2, 0]; fm_lvl = [h_margin+working_width/8, row_4, 0]; pwm_cv_lvl = [width_mm - h_margin - working_width/8, row_2, 0]; triangle_out = [third_col, fifth_row, 0]; square_out = [output_column, row_2, 0]; } // draw panel, subtract holes panel(width); // Top left: clock in, speed pot_p160(); // Left side: meta-step controls // step rotary switch? Special: this needs.

New Pull Request

Labels Milestones