Labels Milestones
Back= knob_radius_top; // just match the top (mm rail_clearance = 8.5; // mm from very top/bottom edge and where it is safe to put the output jacks row_2 = working_increment*1 + row_1; row_4 = row_3 + vertical_space/7; cv_in_1a = [left_col, row_7, 0]; audio_out_1 = [right_col, row_5, 0]; audio_out_1 = [right_col, row_5, 0]; cv_in_2a = [left_col, row_7, 0]; manual_1 = [left_col, row_6, 0]; audio_in_1 = [left_col, row_6, 0]; cv_1b_atten = [right_col, row_2, 0]; triangle_out = [width_mm-h_margin-working_width/4, row_1, 0]; fm_pot = [input_column - h_margin/2, row_1, 0]; pwm_in = [width_mm - h_margin - working_width/8, row_4, 0]; pwm_cv_lvl = [width_mm - h_margin - working_width/8, row_2, 0]; triangle_out = [third_col, third_row, 0]; fm_lvl = [second_col, third_row, 0]; //Fourth row interface placement sync_in = [first_col, fourth_row, 0]; //Fifth row interface placement f_tune = [width_mm/2 - h_margin, top_row, 0]; f_tune = [width_mm/2 + h_margin, top_row, 0]; left_rib_x = hole_dist_side + thickness; width_mm = hp_mm(width); // where to put reinforcing walls; i.e. The thickness of the round part of the indenting cones. [mm] // Length of the rail + a safety margin // margins from edges h_margin = hole_dist_side*4; v_margin = hole_dist_top*2; width_mm = hp_mm(width); // where to put the output jacks working_height = height - v_margin*2 - title_font_size; working_increment = working_height / (8+tolerance/5); // generally-useful spacing amount for vertical columns of stuff col_left = h_margin; col_middle = col_left + (15.6 .
New Pull Request