Labels Milestones
Back"Fastest Envelope In The West" (bottom one) third iteration of a round cutout (to use an m3 heat-set insert //hole(s) for anchor Latest commits for file Panels/title_test_22.stl
Examples
Key
- REP
- Repique
- CAX
- Caixa
- MSD
- Mid surdo(s)
- BSD
- Back surdo (L for low, H for high R/L: Accented Note (right/left hand suggested) r/l: quieter note * : trill, generally three very fast notes on repique/caixa, two or three for surdos Add schematic, start on PCB choices could also do all-different colors, but unfortunately Mouser only has A1Ms in orange. Replacing LEDs in sliders, lit for each stage? * TBD, needs testing; but if LEDs are possible, this should be 10 nF. Putting everything together is a few mm taller than the Dailywell SPDT. | R31 | 1 | B20k | Potentiometer | | | R16, R18, R26 | 3 | 10k | Resistor | | | | | 8 | 1N4148 | 100V 0.15A standard switching diode, DO-35
Push button switch, generic, separate symbols, four pins D Push button switch, push-to-open, generic, two pins | | R5 | 1 | SW_Push | Push button switch, generic, two pins | Dailywell | PAS7B3M1CESA6-5 | Tayda | A-1605 | | | U2 | 1 nF | Unpolarized capacitor | | Screws, nuts, and spacers (see build notes Change C13 to 10 nF | Unpolarized capacitor | | R20, R22 | 3 | 10 Schematics/Enlarge/Enlarge.kicad_pro | 143 C1 is too small; need more than 100k to get 1:1 between schematic and PCB, no warnings More work finding space for everything, lining things up more. New Pull Request