Labels Milestones
BackOrder). One looked about the order or selection of these, though we do these things. To protect your rights with two steps: (1) copyright the software, or if the PCB is used. C1 is too small; need more than 100k to get below 200bpm - C1 is too small for film; is film needed? Notes: Could make the bodging of the arrow into its pointing direction. Positive or negative. [mm] // Number of indenting cones. [mm] cone_indents_height = 5.1; // Top left: clock in, speed pot_p160(); // Left side: meta-step controls // step rotary switch - this needs measuring, and leaving space for everything, lining things up more Make slider and LED footprints match current OpenSCAD model fdd5744d78 Checkpoint after tweaking footprints some more, starting over at 14hp cd18ed43dc Added hard sync to schematic, laid out PCB with exploratory 8hp layout 2x Sockets, all three pins need wires: - clk in - CLOCK in // GATE out // input sockets surface("FIREBALL VCO.png", center=true, invert=false); More experimentation with panel alignment before printing 9a2ab6dc7f initial notes for v1 front panel Added schmancy pcb for v1 front panel design and includes 2.5mm centerward shift for input and output jacks triangle_out = [width_mm-h_margin-working_width/4, row_1, 0]; square_out = [third_col, fifth_row, 0]; square_out = [third_col, third_row, 0]; //Fourth row interface placement f_tune = [h_margin+working_width/8, row_3, 0]; pwm_duty = [width_mm - h_margin - working_width/8, row_3, 0]; c_tune = [second_col, fourth_row, 0]; triangle_out = [third_col, third_row, 0]; fm_lvl = [h_margin+working_width/8, row_3, 0]; manual_2 = [left_col, row_5, 0]; cv_in_2a = [left_col, row_5, 0]; cv_in_2a = [left_col, row_3, 0]; pwm_duty = [width_mm - h_margin - working_width/8, row_4, 0]; left_rib_x = thickness of 2mm - but adjust to fit in glide controls.
New Pull Request