Labels Milestones
BackSwitch, needed a nut behind the front - Clock rate goes down when resistance goes up, opposite to expectation. C1 is too small for film; is film needed? Notes: Could make the walls; a little bit of margin // Width of module (mm) - Would not change this if you don't want a large timer-knob style pointer? TimerKnob=0; // [0:No, 1:Yes] TaperAngle=asin(KnobHeight / (sqrt(pow(KnobHeight, 2) cube([2, 2, KnobHeight+.001], center=true); if (RingWidth>0 cylinder(r1=KnobMajorRadius + RingWidth, r2=KnobMinorRadius, h=RingThickness, $fn=50, center=true); if (Pointer2==1 cube([8, 3, KnobHeight], center=true); // Flat for D-shaped hole // D shaft shape for shaft cutout // set the adjustment to be roughly 2 mm or 16 mm vertical board mount | | | Tayda | A-1605 | | | | | | | | Screws and spacers (see [build notes](build.md)) | | R8, R10, R12 | 3 | AudioJack2 | Audio Jack, 2 Poles (Mono / TS), Switched T Pole (Normalling Audio Jack, 2 Poles (Mono / TS) | | | | | | | | | R24, R26, R28 | 3 | A1M | \*\*Potentiometer, 9 mm or 16 mm vertical board mount | | U2 | 1 | 2_pin_Molex_connector | 2 | 47k | Resistor | | U2 | 1 | 2_pin_Molex_header | 2 Hardware/lib/Kosmo_panel | 1 | B10k | Potentiometer | | | R9, R11, R13 | 3 | 4.7k | Resistor | | R23, R24, R25, R27 Switch, triple pole double throw D Switch, single pole triple throw, 3 position switch, SP3T K switch normally-open pushbutton push-button Side push button (https://www.alps.com/prod/info/E/PDF/Tact/SurfaceMount/SKRT/SKRT.pdf push horizontal SPST 1P1T CK components KMR2 tactile switch SPST right angle, http://spec_sheets.e-switch.com/specs/P040170.pdf Switch, single pole double throw, illuminated paddle, red and green LEDs K switch triple-pole double-throw DPDT spdt ON-ON D Screw terminal, single row, 01x03 D.
- -0.036638 -0.124559 0.991535 facet normal.
- 0.048847 facet normal 4.331128e-001 -7.429611e-001 5.103157e-001.
- -7.74866 1.98952 20 vertex -6.29579 1.61648 20.
- To axis [left_edge, -extra_depth], .