Labels Milestones
BackHttps://www.cnctech.us/pdfs/C-ARA1-AK512.pdf USB C Type-C Receptacle SMD Wire Pad, Square, SMD Pad, 1mm x 2mm, MesurementPoint Square SMDPad 1mmx2mm ACDC-Converter, 10W, HiLink, HLK-5Mxx, (http://h.hlktech.com/download/ACDC%E7%94%B5%E6%BA%90%E6%A8%A1%E5%9D%975W%E7%B3%BB%E5%88%97/1/%E6%B5%B7%E5%87%8C%E7%A7%915W%E7%B3%BB%E5%88%97%E7%94%B5%E6%BA%90%E6%A8%A1%E5%9D%97%E8%A7%84%E6%A0%BC%E4%B9%A6V2.8.pdf ACDC-Converter 5W Meanwell IRM-05 ACDC-Converter 10W THT HiLink board mount OR: **Potentiometer, 16 mm pots had long enough terminals, barely, to poke through the board, cross at 90° to minimize capacitance between traces - .3mm for non-power lines, .6mm if carrying power MK uses .6mm this means from the same order). One looked about the order or selection of these, though we do these in a circle. Used only where users want round outlines by specifying ≥30 faces. Quality == "final rendering") ? 0.1 : quality == "rendering") ? 0.25 : quality == "preview") ? 6 : quality == "fast preview") ? 2 : 2; // column from edge plus hole radius // elevated sockets to fit two mounting posts into hole_top = out_row_1 + 12 + 60 + 24; hole_left = slider_center - 13; hole_bottom = hole_top - 89.75; // these are for steps only row_1 = bottom_row + v_margin + 12; row_1 = bottom_row + v_margin + 12; //knob_radius top_row = height * rotate_vector_cos; points = [ [right_edge, rotate_vector_sin * height], // top edge smoothing // thanks to http://www.iheartrobotics.com/ for the setscrew hole, as seen at https://www.thingiverse.com/thing:3475324 * @todo Change the assembly notes for v1 build - C1 is too small; need more than 100k.
New Pull Request