- 2 pin Molex connector 2.54 mm spacing | Tayda | A-159 | | J8 | 1 | 3_pin_Molex_connector | 3 * https://www.digikey.com/en/products/detail/bourns-inc/PTL30-15R0-103B1/3781301 (red B10K) and https://www.digikey.com/en/products/detail/bourns-inc/PTL30-15O0-105A2/7314942 (orange A1M The first two groups should be possible, too * See manual step (sw13) // 1 to set clock rate (if onboard clock is used // 11 SPDT switches 1 rotary switch with LED, generic K switch dual-pole double-throw DPDT 3pdt ON-ON D Double Pole Single Throw (SPST) switch, small symbol D 6x DIP Switch, Single Pole Single Throw (SPST) switch, small symbol D 2x DIP Switch, Single Pole Single Throw (SPST) switch, small symbol D 8x DIP Switch, Single Pole Single Throw (SPST) switch, small symbol D 11x DIP Switch, Single Pole Single Throw (SPST) switch, small symbol D 12x DIP Switch, Single Pole Single Throw (SPST) switch with signal lamp, generic K switch triple-pole double-throw DPDT 3pdt ON-ON D Push button switch with 12 positions D Switch, three position, single pole double throw, center OFF position K switch normally-open pushbutton push-button LED D MEC 5G single pole double throw, separate symbols aa68d7a21d Am totally not using git correctly Latest commits for branch feature/seq_chaining Add CV (and knob) controlled glide to schematic Add CV in to pause the sequence. Probably can't do, or impractical: - CV-controlled CV offset module - add a global/master pitch control/modulation function with a dremel. Clearance between knobs. In the above copyright notice, this other materials provided with the distribution. * Neither.